About

A small workshop, one printer at a time

Kostanjevec 3D started as a way to turn “can you make me…” conversations into actual objects. [YOUR NAME] designs, prints, and finishes every model that leaves the workshop — there’s no factory line here, just one person, one printer, and a lot of trial and error to get each piece right.

The craft

Every order goes through the same four steps: design, print, hand-finish, ship. Custom requests usually start as a rough idea, a photo, or a sketch — from there the model gets designed (or adapted from an existing one), sliced, and queued up for printing. Nothing goes out the door straight off the plate; supports get cleaned up, layer lines get sanded where it matters, and every print gets a once-over before it’s packed.

The printer

The shop runs on a Snapmaker U1, printing mostly in PLA and PETG depending on what the piece needs to survive — a decorative planter has very different requirements than a phone stand that lives in direct sun. Materials are picked per order, not by default.

Based in [LOCATION]

Kostanjevec 3D has been printing custom orders since [YEAR STARTED], out of [LOCATION]. It’s a small operation by design — small enough that every order gets actual attention instead of being one more line in a queue.

Why custom

Mass-produced plastic is everywhere. The point of this shop is the opposite: things made because someone asked for them, sized and colored the way they actually wanted, not because it fit a product catalog. If you have an idea, see how custom orders work or head straight to the custom order form.